Yeah Google Code sucks and the button won't work. The main menu controls should be self-explanatory. These can be used by any of the output channels M1 to M8 as a source. Adjust the M8 mixer menu to reverse the yaw gyro as required. Setting this to ON allows the board to function without an external RC source. PWM does not require a throttle input in OpenAero2. I'm always happy to make special versions for people. 
| Uploader: | Vizshura |
| Date Added: | 13 December 2012 |
| File Size: | 21.14 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 4289 |
| Price: | Free* [*Free Regsitration Required] |
Stability settings For now, just alter the Mode as described above in "Stability and Autolevel switching". You can therefore do delta, taileron, elevon etc mixing with OpeAero2 without needing special transmitter mixing functions.
You should immediately see values appearing in both columns next to each connected channel. You can change this value at any time, but changing either the number of cells or the minimum cell voltage will over-write opemaero2 LVA.
OpenAero2_User_Guide - nextcopterplus - OpenAero2
Next I tried the option of synching on the stabilisation channel as it is normally a higher channel number, That is called PWM2. Allows you to set the amount of time the status screen is displayed until it is replaced by the idle mode screen.
The rudder input was used by the software to signify that all channel data had been received. These can be used by any opneaero2 the output channels M1 to M8 openaeri2 a source.
Google Code Archive - Long-term storage for Google Code Project Hosting.
When deactivated, OpenAero2 just passes the servo signals from your receiver to the servos. The on-screen graph is drawn using the actual expo table and so gives you an kpenaero2 view of the response curve.
Go back to the status menu. It is recommended that receivers with built-in failsafe be set up and used. Move all surfaces and check openaego2 they move as expected.
Essential Instructions - RC.
See the separate guides for setting up camera stability. The black dot indicates where OpenAero2 thinks "down" is. CPPM users can pick any unused channel. Model type Go into the General menu and change the Mode to that which suits your model.
Use the M6 and M7 mixer menus to reverse the roll gyro as required. Do you need a help? Place the model on a flat surface and chock up the tail or nose until it is level and in its normal flying attitude.
The way it works is this: Set the first channel source to be mixed here. OpenAero2 have a completely flexible mixer which allows it to control just about anything, but comes with three preset mix tables. PID Differential gain for the yaw gyro Note: Stability Control Menu Mode: They should move slightly to compensate and remain in that position. You need to physically disconnect the receiver.
Over-ridden by pressing the failsafe button on the RC Inputs screen. This will be discussed later in the guide. Automatically centers the Yaw axis when in heading hold mode if the yaw has drifted off-center. Make sure all controls are centered and throttle at minimum before calibration. PWM3 is for synching with whatever is on that fifth channel the Oopenaero2 has. Set the amount of channel B required.
The higher the number the faster as gyro is favoured, the lower the more accurate but slower.
No comments:
Post a Comment